How to Configure VPN in Cisco 2820 Router?

December 11, 2009

Please provide me with Command for Cisco Router and advice me for any additional setup is required for that. I am new.

Read the full article →

How do you get a serial interface and line protocol to be up on a cisco router?

December 10, 2009

I have two cisco routers connected with serial cables and they are being configured with a console cable. I set the ip address of both routers 192.168.1.1 255.255.255.0 192.168.2.1 255.255.255.0 and then run a no shut. I exit to exec mode and run a show interface and all I get is Serial is [...]

Read the full article →

Defualt IP Address – What is It?

December 10, 2009

The default ip address 192.168.0.1 is the internet protocol address for many home based broadband routers like for example Netgear routers. It is set at the factory before the device is shipped.

Read the full article →

how do I solve this problem with my Cisco router?

December 9, 2009

I have a brand new Cisco 877, I can access to te internet, but only a small part of it. I am using a different router now because I can’t access Ebay or answers.yahoo with my 877, as if there’s a firewall blocking the traffic.
How do I manage to solve this issue?

Read the full article →

What is the best CISCO router for Home use?

December 8, 2009

What is the best Cisco router to use with my cable modem at home. I know how to configure Cisco IOS, just looking for CHEEPEST router with like 2 Ethernet ports, I can use external switch. Also, looking for ability to VPN into my network.
Don’t want a Linksys, I want a actual CISCO router That [...]

Read the full article →

When the destination network is not listed in the routing table of a cisco router,?

December 7, 2009

When the destination network is not listed in the routing table of a cisco router, what are two possible actions that router might take?
1. The router sends an ARP request to determine the required next hop address.
2. The router discard the packet
3. The router forward packet toward the next hop indicated in the ARP table
4. [...]

Read the full article →

How can I introduce artificial delay on an a Cisco router interface. (long ping times)?

December 6, 2009

We currently have a Cisco 3540 router with some T1/E1 VWIC. We are currently experiencing about a 14ms delay when we ping them. We would like to introduce some artificial delay to get us around 40ms to see if our application can handle latency. I have tried configuring the interface, with delay, and transmitter [...]

Read the full article →

Where to get CISCO CCNA certification course?

December 6, 2009

I like to learn CISCO CCNA so guide me for doing certification course.

Read the full article →

Can I send multicast from a Nortel core router to rmote Cisco router?

December 5, 2009

I have a centralized core Nortel BCN router.There are several remote user who runs Cisco router to communicate with.
My question is If I will send multicast to then what are the steps I have do with these two routers.
Should the original configuration will get affected ?

Read the full article →

Can someone tell me how do I study for Cisco CCNA?

December 5, 2009

I wanted to take Cisco’s CCNA to help further my career in computer networks. How do I study the thick book given to me? What are also the important topics to study in and what do I look out for? Thanks.

Read the full article →

← Previous Entries

Next Entries →